Skip to product information
X-128 Liquid Metal & Paste ULTRA High Performance
CPU & GPU Coolers CPU GPU Cooling
- Silver-Based Supreme Performance
- Gaming PC Thermal Solution
Sale price
Rs. 899.00
Regular price
Rs. 999.00
In Stock
Ships from Bengaluru, India
- Free Delivery 500+
- 7-Day Returns
- Secure Checkout
Delivery FREE on orders Rs. 500+ · Rs. 65 below
COD Pay Rs. 120 now, rest at the time of delivery
Silver-based liquid metal for builders chasing the lowest temperatures their hardware can reach — on gaming PCs, overclocked GPUs and consoles.
Why X-128
- Silver-based formula — pulls heat off the chip far faster than regular paste.
- Up to 40–60°C lower temperatures — the biggest temperature drop under full load.
- Higher sustained clocks — with that much heat gone, CPUs and GPUs stop throttling and FPS stays smooth and steady.
- Built for long sessions — holds its performance through 8+ hour gaming marathons.
Made for
- High-end and overclocked gaming PCs
- Competitive, high-refresh-rate rigs (240+ FPS)
- PS5, PS4 & Xbox — a liquid metal upgrade for cooler, quieter consoles
- Multi-GPU and extreme builds
⚠ Electrically conductive — apply with care
- Apply only on the CPU / GPU die or heat spreader.
- Keep it away from capacitors, VRMs, circuit traces and the motherboard; wipe any excess immediately.
- Do not use with aluminium heatsinks — copper or nickel-plated only.
- Recommended for experienced builders. Damage caused by incorrect application is not covered.
How to apply
Applying X-128 Liquid Metal, safely.
Liquid metal conducts electricity. Take your time, protect nearby components and use only a tiny amount.
- Check your coolerLiquid metal is only for copper or nickel-plated contact plates. Never use it on aluminium — gallium reacts with it.
- Power off and cleanUnplug the machine, remove the cooler and wipe the die and cooler plate with the alcohol wipe until both are completely clean and dry.
- Protect the areaCover the tiny components around the die with Kapton tape or a conformal coating so a stray drop cannot short them.
- Spread a thin filmPlace a very small drop on the die and work it out with the cotton swab until the surface looks like an even mirror. Coat the cooler contact area thinly too. No beads or pools.
- Mount and inspectKeep the board flat, re-mount the cooler evenly and check for any spill before powering on. Then test under load.
Full guide: Liquid metal vs thermal paste – which should you use?
Stuck at any step? Message us on WhatsApp — we will guide you.