Fresh thermal paste is one of the cheapest ways to bring CPU and GPU temperatures down. Old paste dries out, cracks and leaves air gaps between the chip and the cooler, and air is a very poor conductor of heat. This guide shows you how to apply thermal paste correctly on a desktop CPU, a graphics card, a gaming laptop or a console.
What you need
- A good thermal paste, such as Thermal Lexum Q-17 (17.6 W/m·K) for gaming and heavy loads, or Q-12 (13.6 W/m·K) for everyday cooling
- Isopropyl alcohol (90% or higher) or cleaning wipes, and lint-free cloth
- A plastic spatula or card (included with Q-17 and Q-12)
- The right screwdriver for your cooler, and about 15 minutes
Step-by-step: how to apply thermal paste
1. Power off and unplug
Shut the system down and unplug it. On a laptop, disconnect the battery if you can. Touch a metal part of the case to discharge static.
2. Remove the cooler and clean off the old paste
Loosen the cooler screws a little at a time in a cross pattern. Wipe the old paste from both the chip and the cooler base with isopropyl alcohol until both surfaces are shiny and completely clean. Let them dry for a minute.
3. Apply the right amount

For most desktop CPUs, a pea-sized dot (about 4–5 mm) in the centre is enough. Large CPUs and GPU dies are better covered with a thin, even layer spread with the spatula, or with an X pattern. The goal is a thin layer that fills microscopic gaps, not a thick blob.
4. Re-mount the cooler evenly
Place the cooler straight down without sliding it. Tighten the screws a few turns at a time in a cross pattern so the pressure spreads the paste evenly.
5. Test your temperatures
Run a game or a stress test such as Cinebench for 10–15 minutes and watch the CPU and GPU temperatures. Compare them with your temperatures before repasting.
How much thermal paste is too much?
Too much paste spills over the edges and makes the layer thicker, which can raise temperatures. Too little leaves dry spots. If you lift the cooler and see paste covering the whole chip in a thin layer, you got it right.
Thermal paste for laptops, PS5 and Xbox
Laptops and consoles have smaller dies and higher pressure, so use a thin spread layer. Note that the PS5 APU ships with liquid metal from the factory; replacing it needs care and may affect your warranty. Read our guide on liquid metal vs thermal paste before you open a console.
How often should you replace thermal paste?
For most gaming PCs and laptops, every 2–3 years is enough, or sooner if temperatures climb, the fans get louder or the system starts throttling. Hardware that runs 24/7, such as servers and mining rigs, benefits from a durable paste like Q-12 or Q-17.
Frequently asked questions
Can I reuse old thermal paste?
No. Always clean it off and apply fresh paste whenever you remove the cooler.
Which thermal paste should I buy?
Choose Q-17 for gaming PCs, GPUs and heavy workloads, Q-12 for dependable everyday cooling, and X-128 liquid metal only if you are an experienced builder chasing the lowest temperatures. See also: best thermal paste for gaming PC, laptop and PS5.
